Installations

TEEBAUD® is a multi-purpose non-skid underlay pad. It can be used on wall-to-wall carpeting or on smooth flooring surfaces. In order to obtain maximum satisfaction and the best results with TEEBAUD®, here are the installation procedures to be followed:

RUG on wall-to-wall carpeting:

  • Cut TEEBAUD® about 1″-3″ smaller than the rug to be installed
  • Remove the plastic release liner
  • Place TEEBAUD®’s white side down, facing the wall-to-wall carpeting
  • Then place the rug on top of TEEBAUD®’s gray side.

RUG on smooth flooring surface:

  • Cut TEEBAUD® about 1″-3″ smaller than the rug to be installed
  • Remove the plastic release liner
  • Place TEEBAUD®’s gray side down, facing the smooth floor
  • Then place the rug on top of TEEBAUD®’s white side.
Cutting

TEEBAUD® can be easily cut with scissors or a utility knife.

Floor Preparation

Prior to installing TEEBAUD®, the floor should be vacuumed, clean and dry. Do not install TEEBAUD® on a wet floor. In order to obtain a long-lasting non-skid performance, avoid frequent removal and re-installation of TEEBAUD® from its designated installation area.

Oversized Rugs

If several pieces of TEEBAUD® are necessary for one rug, simply apply as many pieces as needed, side-by-side. Taping or splicing is NOT necessary.